Hubbell WGH Serie Instructions D'installation page 2

INSTALLATION INSTRUCTIONS - WGH Glass Wallpack Small Adjustable
READ THOROUGHLY BEFORE INSTALLATION
If your light fixture was supplied with a photocell it
may have a black photocell cap installed on it, see
figure 2 to determine if the cap is installed. With
the cap installed your light will always be on when
power is applied unless a switch is used to turn the
light on or off. If you want the photocell to turn off
the light when it is daylight, remove the cap and
discard.
Your light fixture can be mounted directly to a
junction box. See figure 3 junction box mounting
details. Drill through the housing in this area to
match your junction box screw locations. Make
sure to install the gasket as shown in figure 1.
LUMEN SELECTABLE INSTRUCTIONS
Different lumen levels can be achieved by setting the
controller to the wattage positions shown below.
93139881 Rev-B
Hubbell Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
Due to our continued efforts to improve our products, product specifications are subject to change without notice.
© 2021 Hubbell Lighting, All Rights Reserved • For more information visit our website: www.hubbelloutdoor.com
SAVE THESE INSTRUCTIONS
Photocell Cap
Location
Figure 2
Figure 3