Installation Steps - Rampage California Brief Top Instructions D'installation

Installation Steps

Place the top onto the vehicle. Placing header channel onto
windshield front. Unfold the cover fabric then pull over sound
bar and roll cage, working toward the rear of the vehicle.
4
TIP: Rampage door surround kit that has been designed specifically for the California Extended Brief Top™.
Attach the brackets to the windshield header using the knobs included
to secure the header to the vehicle.
5
Locate the ceiling adjustment straps at the corners of the ceiling
panel. Wrap the straps around the roll bar and seatbelt stud
toward the inside of the Jeep, then back up to the strap
adjustment buckle.
Tighten and repeat for the passenger side. Adjust each side
to position the top evenly (See diagram).
6
Open all doors. Attach the hook and loop straps around the roll
bar to secure the brief to the vehicle.
7
TIP: The factory door surrounds can be used.
NOTE: Actual application may vary slightly from illustrations.
Wrap the 2 straps attached to the main section of fabric around
the rear-middle of the sound bar. Insert plastic hooks into the holes
on the underside of the sound bar. Tighten the strap until snug.
3
Page 2 of 3
Main Roll Bar
Straps
View from the underside
4
1
2
light
Straps