The FT-EZGO from Firstech will unlock/disarm the vehicle when in range. It will also
lock/arm and unlock/disarm the vehicle when you press the button on the EZ100-R.
Installing The FT-EZGO
Step 1 : Flash your CM6 Series control module for FT-EZGO compatible firmware.
Step 2 : Set Option 1-14 to Setting 3
Step 3 : Connect included 6 Pin to 6 Pin with Ground Wire to control module. If connecting
to a 4 Pin to 4 Pin antenna, use the included 6 Pin to 4 Pin adapter.
Step 4 : Connect the ground wire from the included 6 Pin to 6 Pin cable to vehicle's ground.
Warning: Failure to connect this wire WILL result in damage to your FT-EZGO antenna
(ANT-RFID).
Step 5 : Connect your antenna to the ANT-RFID. This is the blue 6 Pin port. If you have
a 4 Pin antenna cable, use the included 4 Pin to 6 Pin adapter.
Step 6 : Find a spot to mount your ANT-RFID on the windshield. This is recommended for
optimum range. For more specific mounting location information visit us at
www.firstechonline.com under the Authorized Tech section document titled:
"FT-EZGO Recommended Mounting Locations."
Step 7 : Program your EZ100-R and additional RF Kit remotes to the control module.
(Maximum 3 Remotes including EZ100-R).
You are now ready to test your FT-EZGO system.
Testing The FT-EZGO
Step 1 : Turn the auto unlock feature by holding the button on the EZ100-R for at least
8 seconds. You will get one parking light flash and/or siren chirp. Hold the button again for
at least 8 seconds and you will get two parking light flashes and/or chirps showing that
the auto unlock feature is off.
Step 2 : Arm/Lock the vehicle and wait at least 15 seconds.
Step 3 : Walk up to the vehicle and it will automatically unlock/disarm.
FT-EZGO Installer Setup Card