Extreme Max Slider Trax Straight Aluminum Base Mount Instructions D'installation

The Rail Accessory Mount is designed to fit Lund Rail Systems
and may not work with other accessory tracks.
Caution:
• Always wear ANSI-approved eyewear and other safety
equipment during installation of the rail accessory mount and
while installing accessories on the mount.
Accessory Mounting:
Install accessories to the mount by drilling directly through the flat surface of the mount. Always remove the
mount from the gunwale before drilling.
Customer Service: 651-357-1862 | service@extrememax.com | www.extrememax.com
Slider Trax Straight Aluminum Base Mount
™
Installation Instructions
1. Remove the knob screw from accessory mount allowing the
slide insert to be removed and the hinge bracket to have a full
range of motion when installing.
4. Center the slide insert and use the knob screw to tighten the
set screw, expanding the hinge bracket down into the lower
edge of the groove until it is snug. The accessory mount athe
rail track.
Optional set screw supplied for permanently placement without
tools.
3005.4134 - Pack of 1
2. Locate the desired position along the rail
track. Place the accessory mount into
the rail groove so the lip catches the top
edge of the rail track.
3. Place the slide insert so the lip catches
the bottom edge of the track and slide
into the accessory mount.
3262ex0219