Novellini 40465ELE-30 Guide D'utilisation Et D'entretien page 20

ENGLISH
Description of remote control:
After inserting the batteries, the remote control searches for the
sauna with which it must dialogue.
This is why the bath must be connected to the supply mains.
When this operation has been completed successfully (soon
after inserting the batteries), the remote control emits a beep.
Your remote control is now ready for use.
To optimise the life of the batteries, the display goes off 20
seconds after the last command. To turn it on again, lightly press
any point of the display.
Turning on:
Hold the display down until the introduction appears.
Main commands:
1- HYDROMASSAGE
2- AUDIO FUNCTIONS
1
3- DISINFECTION
4- CROMOLIGHT
3
5- ALL FUNCTIONS OFF
6- ALARM
5
Hydromassage menu:
To enter the hydromassage menu, press the 1 button in the main
menu.
9
10'
BACK TO THE
MAIN MENU
Selecting the desired hydromassage is done by pressing the 6-7
buttons repeatedly.
WHIRLPOOL
OFF
AIRPOOL
OFF
Press the 8 button to confirm and start the hydromassage.
To select the same hydromassage as that chosen last time, pres
the 8 button and the hydromassage will start.
If you want to change the hydromassage duration, enter the
Duration sub-menu by pressing the button 9.
12:33
2
4
6
12:33
6
7
8
MANUAL AUTOMATIC
CONTINUOUS TIMED
Hydromassage duration sub-menu
By pressing the (+) and (-) buttons, the hydromassage duration
can be adjusted.
Once the desired time has been set, press the 10 button to
confirm.
To start the hydromassage, press the 8 button.
The screen displays the time remaining for the hydromassage,
and the 1 button is lit to show that the hydromassage is in use.
NOTE: If the duration of the hydromassage is set to 0, the
hydromassage will stay on for about 1 hour from last operation.
If water level in the bath is too low, the symbol 11 will start
flashing. In such a case fill the bath up with more water and the
hydromassage will start automatically.
To prevent a quick decrease of water temperature, the bath is
equipped with a heater that is automatically started when the
Whirlpool hydromassage is on.
11
Whirlpool sub-menu:
Whirlpool function can be selected by pressing the 6 button
more than once.
Whirlpool manual function:
By keeping the 6 button pressed, you can adjust the intensity of
the Whirlpool massage. When the button is released, the desired
value is set.
-20-
12:33
10'
10
10' 12:33
12:33
M
12:33
10'