Pre-Installation - Altra Furniture E35WF Mode D'emploi

Pre-installation

PLANNING INSTALLATION
Before you begin assembly, locate the instructions and hardware. Compare all parts with the Hardware Included and Package
Contents lists. Be sure you have all the parts and can identify them. A helping hand is always good. Assemble your fireplace with an
adult assistant if possible. Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately 5-20
minutes.
Before assembly, use scissors to unwrap the parts from the packaging. Do not use a box cutter or exacto-knife, as you may cut into the
heater pieces inside the box and damage the finish. Check for the red hardware bag located inside the packaging, taped to the top of
the box. Do not discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
CAUTION: This carton includes a GLASS panel! Always use extreme caution when handling glass. Failure to do so could
result in personal injury or property damage.
SPECIFICATIONS
ELECTRICAL CONNECTION
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of
fire, electrical shock, and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to
inspect the fireplace and replace any part of the electrical system which has been under water.
A properly grounded outlet is required to operate this appliance. Preferably, the appliance will be on a dedicated circuit, as other
appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the fireplace is in operation. The unit comes
standard with a 1.8 m / 6 ft long 3-wire cord, exiting out the back of the fireplace. Plan the installation to avoid the use of an extension
cord. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power
strip).
GROUNDING INSTRUCTIONS
This fireplace is for use with 120V power sources. The cord has a three-blade,
grounding-type plug. An adapter is available for connecting three-blade grounding-
type plugs to two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground, such as a properly grounded
outlet box. The adapter should not be used if a three-slot grounded receptacle is
available. (Note: Grounding adapter use prohibited in Canada)
4/37
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Metal
Grounding Lug
Screw
Cover of Grounded Outlet Box