Important - MayPole Challenger Mageo 170 Instructions De Montage Et D'entretien

GB
Breathable Motorhome Cover
Fitting And Care Instructions

Important :

• Do NOT attempt to fit the cover in windy conditions.
• Do NOT use your motorhome's heating system with the cover fitted.
• Do NOT attempt to drive your motorhome with the cover fitted.
• When opening and closing a zip, always ensure the cover surrounding it is straight.
and not too tight. This will prevent excessive strain and possible failure of the zip.
• Do NOT over-tension straps as this may damage your cover.
• To help prevent the natural growth of mould inside the vehicle; regular ventilation and the
use of a dehumidifier is recommended in long term storage.
• During long term storage it is recommended the exterior of the vehicle is regularly cleaned
to help minimize the possibility of mould growing between the body work and the cover.
Before fitting your cover :
• Remove, fold away or cover any sharp or fragile objects (such as aerials, guttering,
wing mirrors, awnings and ladders etc) on the exterior of your motorhome to avoid
damage to both them and the cover.
• Close all windows and rooflights etc.
• Ensure that fridges and heaters etc are turned off and the handbrake is applied.
• It is preferable, but not essential, that your motorhome exterior is dry before fitting
your cover. In order to prevent scratching, it MUST be clean and free of any loose
particles or grit.
Fitting your cover :
Two people and the careful use of stepladders or a stable platform will be required
as the cover is large, heavy and needs to be passed carefully over all sections of your
motorhome. WARNING : If using stepladders or a platform you will be working at
height and should follow carefully the stepladder / platform manufacturer's safety
instructions. You should not attempt to fit the cover from the ladder but only to use
the ladder if required to assist people on the ground.
1. Open out the cover. The front section is clearly identified with a "FRONT" label.
2. Unzip the rear panel.
3. Starting from the front and working towards the rear, lift the cover carefully over
the roof and all protruding objects. If necessary, unzip the front section also.
4. Adjust the cover's position until an even fit all over is achieved.
5. Close the zips carefully and fasten the Velcro tabs, as shown in the photo on the box.
6. Secure the sides of the cover with the straps provided. Pass each strap under your
motorhome and secure to the corresponding buckle on the opposite side.
7. Adjust all straps as required to give a good fit, including those on the front and
rear, as shown in the photo on the box.
Care of your cover :
• Allow the cover to dry completely before storing in the bag provided.
• Do NOT machine wash or tumble dry this cover. Remove dirt with a soft sponge
and warm water. Do NOT use detergent.
• Do NOT expose this cover to sparks, flames or other sources of ignition.
motorhome cover.indd 2 21/05/2021 15:38:21