Emmaljunga NXT90 Mode D'emploi page 42

Carrycot
1
ASSEMBLY OF THE CARRYCOT
1:1 To erect the carrycot pull the bar using the easy pull handle along the bottom of the carrycot towards the
plastic stops. Repeat both in the foot end and the head end.
1.2 Press into place the two press studs on the easy pull handle on the bottom of the carrycot. Repeat both in the
foot end and the head end (only on certain models).
WARNING Before using the carrycot ensure that the four press studs are fastened to the bottom of the
carrycot and the carrycot frame is held firmly in place (only on certain models).
1.3 Push back the backrest to the reclining position.
1.4 Remove the mattress from the plastic bag (discard safely) The bottom of the carrycot is made of wood.
Insert the mattress.
WARNING Do not use additional mattresses in the carrycot. Use only the Emmaljunga original mattress that
comes with the pram.
WARNING Risk of suffocation. Do not let children play with plastic bags.
1.5 Press both buttons on the inside of the hood and pull it up.
Attach the apron using the velcro straps on each side of the carrycot
The hood can be folded up and down in the desired position by pressing both buttons on the inside of the hood.
1.6 The Hood
Hood covers are easily removable by unzipping the hood and removing from the frame.
1.7 The hood is attached to the carrycot with velcro strips.
1.8 For ventilation, open the zip on the hood.
You can fasten the hood in place by folding under and securing it with the press stud on the inside of the hood.
The ventilation and UV/Insect net on the back of the hood is now visible. (only on certain models)
2
ATTACH THE CARRYCOT
2:1 Put on the brake. Lift the carrycot with the handle and place it onto the frame. Press down so that the
carrycot locks into place you will hear a "click" on both sides.
WARNING Always check that the carrycot is properly attached in the locked position on both sides.
2:2 WARNING Never use the carrycot in the position with the hood placed towards the handlebar (see picture).
The hood on the carrycot should always be placed away from the handlebar
3
REMOVE THE CARRYCOT
3:1 Put on the brake. Under the carrycot base, push in the button and pull the handle towards you. Lift the
carrycot upwards.
WARNING Always check that the carrycot is properly secured in the locked position on both sides.
3:2 WARNING Always use the carrycot lifting handle as illustrated. This is very important!
WARNING Never leave the carrycot near the stairs, on the top of a table or in places where it can fall off.
WARNING Do not use the carrycot as a cradle outdoors or on uneven surfaces.
WARNING Do not use the carrycot as a bed for your child.
3:3 WARNING Never lift the carrycot with the lifting handle as illustrated. This is very important!
UV/INSECT NET (only on certain models)
4
4:1 Attach the UV/Insect net using the zip on the edge of the hood.
4:2 To secure the insect net fasten the press stud to the inside of the hood (See picture). Repeat on the other side.
5
REMOVEABLE INNER LINING (ONLY ON CERTAIN MODELS).
5:1 Removable inner lining. We recommend hand washing. Drip dry.
6
ADJUSTING THE BACKREST IN THE CARRYCOT
6:1 Lift the plastic backrest, press out both of the plastic legs.
42
NXT 90 v 3.2