If It Is Necessary To Stop A Cycle - OTC 5281 Manuel De L'utilisateur

Pre-Treament Cycle continued
1. After the DPF has been loaded into the unit
according to the instructions outlined in Load
the DPF,
4
Press
The word USER appears on the display.
2
Press
This cycle takes about 12 hours.
2. After the Pre-Treatment Cycle is complete,
use the Regeneration Cycle to finish
regenerating the DPF.

If it is Necessary to Stop a Cycle

There are two ways to stop a cycle:
•
Press STOP / BACK.
ABRT appears on the digital display. The unit
may be restarted again by pressing ENTER /
START.
•
Turn OFF the power switch.
555914 Rev. E, November 3, 2015
ENTER/
START
WARNING: Opening the
chamber door during a cycle
allows hot air to escape and,
under certain conditions,
could cause a fire. These
conditions may include an oil
soaked DPF or operating the
unit in a location that contains
flammable materials.
CAUTION: To prevent damage to the DPF,
•
Do not stop a cycle by disconnecting
the power. Under certain conditions, the
controller interprets a power interruption
as a power failure and will turn the unit
back on when power is reconnected.
•
Do not open the door to the chamber
during a heating procedure. Opening the
door can cause thermal shock by cooling
a hot DPF too rapidly, resulting in cracks.
Operation
9