Inspection And Maintenance - Perel Tools WHW420 Mode D'emploi

3. Detach the hook from the shaft and turn the handle counter-clockwise
to reel out the line. The line and hook must be routed under the
shaft [3].
Warning! Make sure that the line does not get knotted, twisted,
kinked or damaged.
Warning! Leave at least 4 full turns of line on the drum.
4. Attach the line to the load. For this purpose, carefully follow the
instructions of the line/hook manufacturer.
5. Place a heavy blanket or rug (not incl.) over the line.
Warning! Keep all bystanders away from the winch, the line, and the
load.
6. Place the pawl [2] in the reel-in position [a].
7. Turn the handle clockwise to reel in the load.
When winding the line on the drum, pack the coils tightly side by side,
so that the next layers cannot slip between the coils.
8. When the load is reeled in, secure it.
9. When the load is secured, place the pawl in the reel-out position [c]
and turn the handle counter-clockwise to release the strain on the line.
10. Remove the blanket or rug, and detach the line from the load.
11. Place the pawl back in the reel-in position [a] and turn the handle
clockwise to wind the line on the drum.
12. Attach the hook to the shaft.

9. Inspection and Maintenance

Only perform the maintenance as described in this manual. Any
other repair or maintenance must be performed by a qualified
service person using only identical replacement parts. This ensures
that the safety of the device is maintained.
Before Each Use
Salts, chemicals, and rust can affect components. Before each use, inspect
the general condition of the winch and line. Check for the following aspects:
 All hardware is tightly fixed.
 Moving parts are properly aligned and free to move.
 Parts are not broken or cracked.
 The line is not frayed, kinked, or damaged in any other way.
 Check for any other condition that may affect safe operation.
After Each Use
After use, wipe the external surfaces of the winch clean with a cloth.
V. 01 – 11/04/2014
WHW420
11 ©Velleman nv