PrimeCables Cab-AG566 Manuel De L'opérateur page 3

Amps from Tool Nameplate 25' length
0-5 amps 16 ga.
5.1-8 amps
16 ga.
8.1-12 amps 14 ga.
12.1-15 amps 12 ga.
15.1-20 amps 10 ga.
3
IMPORTANT SAFETY INSTRUCTIONS
5. TOOL USE AND CARE
a. Use clamps or other practical way to secure and support the workpiece
to a stable platform. Holding the work by hand or against your body is
unstable and may lead to loss of control.
b. Do not force tool. Use the correct tools for your application. The correct
tools will do the job better and safer at the rate for which it is designed.
c. Do not use tools if switch does not turn it on or off. Any tool that can not
be controlled with the switch is dangerous and must be repaired.
d. Disconnect the plug from the power source before making any
adjustments, changing accessories or storing the tool. Such preventive
safety measures reduce the risk of starting the tools accidentally.
e. Store idle tools out of reach of children and other untrained persons.
Tools are dangerous in the hands of untrained users.
f. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are easier
to control.
g. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the tools operation. If damaged,
have the tools serviced before using. Many accidents are caused by poorly
maintained tools.
h. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool, may become hazardous
when used on another tool.
6. SERVICE
a. Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
b. When servicing a tool, use only identical replacement parts. Follow
instructions in the maintenance section of the manual. Use of unauthorized
parts or failure to follow. Maintenance instructions may create a risk of electric
shock or injury.
7. Hold tool by insulated gripping surfaces when performing an operation
where thecutting tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposedmetal parts of the tool "live" and
shock the operator.
8.ENSURE THE EXTENSION CORD YOU USE IS OF SUFFICIENT GAUGE
FOR ITS LENGTH.
Recommended Minimum Wire Gauge for Extension Cords
50' length 75' length
16 ga. 16 ga.
16 ga. 14 ga.
14 ga. 12 ga.
12 ga. 10 ga.
10 ga. 10 ga.
9. STAY ALERT.
Watch what you are doing & use common sense. Don't operate any tool when
are tired.
100' length 150' length
14 ga. 12 ga.
12 ga. 10 ga.
10 ga. Do Not Use
10 ga. Do Not Use
Do Not Use Do Not Use
200' length
12 ga.
Do Not Use
Do Not Use
Do Not Use
Do Not Use