Installation And Configuration; Technical Data - SOMFY TaHoma BeeCon Mode D'emploi

EN

Installation and configuration

Prerequisites for installation
It will be necessary to note down the PIN for the TaHoma BeeCon box (this number can be
found on a label affixed to the box, and will be requested when the product is activated).
Installation
Connect the power-supply cable to the
Please use a
Place the TaHoma BeeCon box at least 30 cm from the internet modem.
Do not place the box near a metallic surface and/or inside a duct containing electric cables.
Do not use the box in areas where devices using radiofrequency transmission are prohibited
(please refer to local standards in application)..
Do not place the interface near devices which could be affected by radio waves.
Configuration
- Refer to the mobile application user guide for any information about device paring.
- Refer to the product's user guide to set it in configuration mode.

Technical data

Housing
- Index protection rating IP30.
- Operating temperature +0°C to 35°C.
- Maximum operating altitude: < 2000m.
- Pollution category: Class 2.
- Operating humidity: between 30% and 85%.
- Dimensions (l x w x h) 170 x 75 x 75 mm.
- ABS-HB plastic housing.
- Pollution degree: PD2.
- Overvoltage category: OVC II
- Consumption in normal operation:
Continuous 5V/2A
continuous 5V/2A power-plug.
micro-USB connector.
Radio
- Frequency used and maximum power used:
- 2.4000 GHz - 2.4845 GHz / erp<25mW
according to Wi-Fi and Zigbee standards.
- 433,50 à 434,790 MHz e.r.p. < 10mW
according to RTS standard.
- Receptor class: 2
Mains adapter (if provided)
- Input: 100V-240V ~ 50Hz-60Hz.
- Output: 5V continuous 2A.
06