Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
50-001-650
INSTALLATION
Mounting
The box of the receiver is IP 67 so it can be mounted indoor or outdoor. It has to be fixed vertically so the cables
enter into the box from the bottom.
Choose a place for the receiver not to be affected by noise and disturbance. The receiver performance depends
on the electromagnetic environment.
•The led called Reception gives you information about the electromagnetic environment. When the led is off,
there is a high quality RF reception. But when this led is on, the place is noisy.
•The output led indicates that the RF receiver recognises a signal from a remote.
•The status LED indicates the status of the communication between the receiver and the controller. If OFF,
then the communication is good. If ON, there is a communication problem between them.
Wiring
Pass the cables through the grommets for a proper sealing.
When loop input (B+, B-) is not used, insert the dedicated jump close to the loop terminal.
50-001-
FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France
www.fdimatelec.com 2
Publicité
Table des Matières
