McGrey Rockit ST Mode D'emploi page 4

carefully the tremolo bar, you can release strings (tuning will go down), if you drag tremolo bar you can bend the
strings and tuning will go up.
Amplifier: Specifications and operation
Connect your electric guitar with amplifier INPUT (1) jack by using the guitar cord. Make sure that VOLUME
control (5) is set to "0" before you switch ON amplifier power (8). Switch on the amplifier, and the red LED (2)
indicates power on. Use TONE control (6) to adjust tone of guitar sound. Set overall volume by using the VOLUME
(5) control. With Channel select button (4) you can select Clean sound or Overdrive sound. With GAIN control
(3) you can adjust the level of distortion. Set to middle position when you start playing.
PHONE (7): 6.35mm headphone output jack. W hen headphones are used, the internal speaker is deactivated.
Ensure that the volume control has been reduced before beginning to play with the use of the headphones, and
then slowly increase the volume to comfortable listening level.
Tuner: Specifications and operation
Rocktile CL-110: Cliptuner / wind instruments tuning C, F, Bb, Eb / Size: 89mm x 53mm x 18,5mm
Battery: CR2032
430Hz ... 450Hz, tuning range A0 (27,5Hz) ... C8 (4186 Hz)
A4 Frequency:
Items of tuning: C (chromatic), G (Guitar), B (Bass), V (Violin), U (Ukulele), W (Wind instrument)
Battery installing: Open the device on the backside and insert the battery. Please mind correct polarity. Then
close the battery cover. To power on the tuner, press On/Off button (1) for 1 sec. By slightly pressing mode
button (2) you can choose the instrument C/G/B/V/U/W you want to tune. In wind instrument mode (W) you can
set the keynote by constantly pressing button (2) to C, F, Eb or Bb. The Keynote will be shown on LCD display.
When the tuner is in guitar mode (G), you can choose flat tuning modes flat b and bb by constantly pressing
button (2). By pressing button (1) several times, you can set A4 frequency from 430Hz to 450Hz. Clip the tuner
to your instrument and play a note. Indicators >>> show too low tuning, indicators <<< show too sharp tuning.
Current key is displayed on LCD display. To power off your tuner press On/Off button (1) for 1 sec. The tuner
will be powered down automatically if there is no button operation or signal input for more than 3 minutes.
Musikhaus Kirstein GmbH
Bernbeurener Straße 11
86959 Schongau / Germany
Phone 0049-8861-909494-0 / Fax 0049-909494-19