AGA marvel ML24BN Instructions D'installation, D'utilisation Et D'entretien page 13

WARNING
!
Use extreme caution with the articulated hinges. The
hinge is self closing and many pinch points exist prior
to built-in installation. Do not remove the cabinet "Z"
bracket from the top of the cabinet.
Cabinet
"Z" Bracket
Figure 15
"P" clamp
and screw
Figure 15b
Bottom of
door
Press and hold down this
tab on the wire connector
and pull the connector apart.
Figure 16
OVERLAY DOOR PANEL INSTALLATION
Loosen (do not remove)
these 2 phillips head
screws on the top and
bottom hinges
Figure 15a
Wire connector
see Figure 16
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 17. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
Holes in
gasket
retainer.
Figure 17a
Figure 17
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 18 and 19 for a left hand door
model or Figures 20 and 21 for a right hand door model.
13
Overlay panel
flush with top
of door.
Overlay panel to
be centered on
width of door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.