GOAL ZERO ROCKOUT 2 WIRELESS Mode D'emploi page 7

TECHNICAL SPECIFICATIONS
USB Cord (Input)
®
Bluetooth :
®
Bluetooth Technology
Line of Sight Range:
Audio:
Speakers
Amplifier
General:
Chainable
Weight
Dimensions
Operating Usage Temp.
Certs
Warranty
Be sure to ACTIVATE YOUR WARRANTY at goalzero.com/warranty
10
5V, up to 0.3A (1.5W max)
®
Bluetooth Ver 3.0
30 ft (10m)
2x 40mm, 3W drivers
Stereo, 3W max, 70dB SNR,
100Hz-20kHz
Yes
1 lbs (454g)
7 x 3.75 x 2.5 in
(17.8 x 9.5 x 6.4 cm)
32-104 F (0-40 C)
12 months
FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced raido/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, and including interference
that may cause undesired operation.
RF warning statement:
This device has been evaluated to meet general RF exposure requirement.
This device can be used in portable exposer condition without restriction.
Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
IC:
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.