Hubbell AIRO Instructions D'installation

INSTALLATION INSTRUCTIONS - AIRO
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt
should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
NOTE:
- This luminare is designed for outdoor lighting applications with ambient tempertures ranging from -40°C to 40°C.
-
Universal input voltage 120-277VAC, 50/60 Hz; 347/480VAC
- Surge Protection - 20kA; Shuts off at end of life.
- For replacement LED Assemblies and Drivers please contact Hubbell Lighting for any replacement parts.
-
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
WARNINGS:
Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed
when replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible
injury to the individual installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
Tools Required:
-
Torque Wrench
- 3/4" Wrench
- T-20 Torx bit
- 1/2" Socket Driver
93131846 Rev C
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
INSTALLATION
INSTRUCTIONS
AIRO
READ THOROUGHLY BEFORE INSTALLATION
SHEET 1 OF 2
www.hubbelloutdoor.com