Shutting Down - Black & Decker Flash Serie Guide D'utilisation

SWITCHING LAMINATING MODES
COLD TO THERMAL
Select the thermal mode setting by pressing the appropriate button. The button will
flash while the laminator is warming up. Once the appropriate temperature is
reached, the light on the selected mode button will remain steadily lit and the 3 beep
audible alert will sound. The machine is now ready for use.
THERMAL LAMINATING MODES
Select the thermal mode setting by pressing the appropriate button. The button will
flash while the laminator adjusts to the appropriate temperature. Once that
temperature is reached, the light on the selected mode button will remain steadily
lit and the 3 beep audible alert will sound. The machine is now ready for use.
THERMAL TO COLD
Select the cold mode setting by pressing the COLD button. The button will flash
while the laminator is cooling down. Once the appropriate temperature is reached,
the light on the COLD button will remain steadily lit and the 3 beep audible alert will
sound. The machine is now sufficiently cooled and ready for use.
NOTE: Due to the time required for the laminator to cool when switching to a
lower temperature or cold mode, it is recommended to always perform laminat-
ing projects in order of cold to most thermal (COLD > 3 mil > 5 mil).
1. While the machine is still hot, feed the included cleaning sheet
through the laminator. The sheet is designed to remove any
adhesive residue that may bleed out onto the rollers during
laminating. It will also ensure continued performace.
2. Press the power button to shut off the laminator and unplug
the power cord. Give the laminator sufficient time to cool before
storing.
3. Loop the cord around the integrated cord wrap and place
laminator in original shipping carton. Store in a cool, dry location.

SHUTTING DOWN

7