Side Discharge Chute; Cutting Height - CubCadet A Serie Manuel De L'opérateur

C
C
(b)
(a)
Figure 2-5
6. The rope guide is attached to the right
side of the upper handle. Loosen the wing
knob (a) which secures the rope guide. See
Figure 2-6.
A
(a)
B
(a)
C
Figure 2-6
a. Hold blade control against upper
handle.
b. Slowly pull starter rope handle
from engine and slip starter rope
into the rope guide.
c. Tighten rope guide
wing knob (a).
d. Use cable tie(s) to secure cable(s) to
lower handle.
Grass Catcher (If Equipped)
1. Follow steps below to assemble the grass
catcher (if needed). Make certain bag is
turned right side out before assembling
(warning label will be on the outside). See
Figure 2-7.
a. Place bag over frame so that its
black plastic side is at the bottom.
b. Slip plastic channel of grass bag
over hooks on the frame.
B
(a)
(b)
2. Follow steps below to attach grass
catcher: See Figure 2-8.
a. Lift mower rear discharge door.
b. Place grass catcher into the slots
in the handle brackets. Let go of
discharge door so that it rests on
the grass catcher.
D
To remove grass catcher, lift mower rear
discharge door. Lift grass catcher up and off the
slots in the handle brackets. Release mower rear
discharge door to allow it to close rear opening
of mower.

Side Discharge Chute

(If Equipped)
Your mower may be shipped as a mulcher.
To convert to side discharge, make sure grass
catcher (if equipped) is off the unit and mower
rear discharge door (if equipped) is closed.
A
Figure 2-7
B
A
B
Figure 2-8
1. On the side of the mower, lift the mulch
plug. See Figure 2-9.
Mulching Plug
2
Figure 2-9
2. Slide two hooks of side discharge chute
under hinge pin on mulch plug assembly.
Lower the mulch plug.
NOTE: Do not remove mulch plug at any
time.
Adjustments

Cutting Height

The cutting height adjustment lever is located
above the front and rear right wheel.
NOTE: On select models, the front cutting height
adjustment lever is located above the front left
wheel. Refer to Figure 2-10 and the following
instructions to adjust cutting height.
2
Higher
3
Lower
1
2
Lower
Figure 2-10
1. Pull the cutting height adjustment lever
towards wheel.
S 2 — A & S
ection SSembly
1
Higher
3
1
-U 7
et p