Repair Information - Cooper Greengate LiteKeeper 4 Serie Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

System Reset and Clear Commands

Under certain circumstances, you may want to reset the

LiteKeeper 4®. There are two different types of reset

commands available in the LiteKeeper 4® system: a soft

reset command and a clear reset command.

Soft Reset Command:

The Soft Reset Command reboots the

microprocessor. It will not cause loss of panel programming.

To perform a Soft Reset Command, press and then

immediately release the reset button located above the

switch wiring channels in the low voltage section. The

display will go blank then read "Initializing..."

Clear Settings Command:

used to remove all programming from a LiteKeeper 4®

unit. It should be done before programming to the unit

for the first time or when asked to by a Technical Support

representative. Please use caution with this command!

When performing a Clear command, all relay loads will turn

OFF . Use the ALL ON override switch to keep lighting ON if

necessary.

To Perform a Clear Command:

the Reset Button. Wait for the screen to initialize. Hit

the key sequence "A, B, C, D, *. " The display will read

"Initializing" again. The unit is now cleared to factory default

programming.

Programming the LiteKeeper 4

The LiteKeeper 4® is programmed either through the

keypad onboard interface or through the optional Keeper

Enterprise Software. Please refer to Programming Guide

that came with the unit to program via the keypad or to your

Keeper Enterprise Manual for programming details. It is

recommended that a Clear Settings command be performed

on the controller before the first programming is done to

clear any test data that may be left in the controller from

factory testing.

LiteKeeper® 4

A clear settings command is

Reset the panel, using