Rondson Segon AME Serie Notice D'utilisation page 18

2. Scan for Bluetooth devices and look for it in the list of available devices (ensure that the amplifier is powered on and within 30-50
meters reception range)
3. Select the blue tooth and the sending device should confirm that it is connected as an audio device
4. Play audio from the sending device, ensuring that volume controls are not turned down/muted
5. Turn up the MEDIA volume control on the amplifier to the required level
If the Bluetooth signal is lost, it may be necessary to re-select the Bluetooth on the sending device.
The Previous, Next and Play/pause buttons will operate in Bluetooth as remote playback controls. Holding the Previous track or Next
track buttons will adjust the output volume of the player.
USB/SD Playback
Push a USB pen drive into the USB port and/or an SD card into the SD card input.
Press the CD/USB/SD button to ensure that the player is set to play from the required memory device. Press the PLAY/PAUSE
button to play the current track and press again to pause as needed.
Searching and playback of tracks is the same as described above for the CD player
FM Tuner
Press the FM select button to switch to the FM tuner function. Use the Previous or Next buttons to select a stored channel.
Tuning and storing stations
Use the Forward/Reverse seek buttons to manually tune the frequency in steps of 0.05MHz
Alternatively, press and hold the Forward/Reverse seek buttons to auto search for available stations.
Upon finding a station, the auto search will stop, giving the option to store this station.
At this point, pressing the PLAY/PAUSE button will flash a "00" channel number in the display.
Use the Previous/Next buttons to select an appropriate channel memory.
Press PLAY/PAUSE again to confirm and store the station into the selected channel memory.
Auto search can be stopped at any time by pressing the Forward/Reverse seek buttons.
WWW.RONDSON.COM
8