VOSS.farming profiCUT Mode D'emploi page 24

Fault/Problem
Motor gets hot
Motor vibrates
Motor is very loud
Motor runs very
slowly
Fault /Problem
Upper blade is not
moving
Upper blade does
not move over
the entire running
surface
Clipper head gets
very hot
Blades cut badly
24
Motor
Cause
1. Air filter clogged
2. Blade tension is
too high
3. Blade and/or head
are dry
4. Defective ball
bearing
1. Rotor runs out of
round
2. Bearings are worn
out
3. Fan wheel broken
Bearings seized up
1. Carbon brushes
worn out
2. Defective rotor or
stator
Clippers head/Blades
Cause
Defective reduction
gearing
1. Eccentric knocked
out
2. Eccentric shaft
defective
1. Blade tension is too
high
2. Blade or head are
dry
1. Blade tension is too
low
2. Blades have rust
on them
3. Blades are dull or
poorly sharpened
INSTRUCTION MANUAL VOSS.FARMING PROFICUT
Solution
1. Clean or replace the air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this solves
the problem and the machine stops
cutting, the blades must be sharpened.
3. Lubricate the blades/ clipper head.
4. Contact the service department.
Contact the service department.
Contact the service department.
Contact the service department.
Solution
Contact the service department.
Contact the service department.
1. Adjust the blade tension with the
tensioning nut. If this solves the
problem and the machine stops
cutting, the blades must be sharpened.
2. Oil the blades/clipper head.
1. Increase the blade tension with the
tensioning nut.
2. Have the blades sharpened in a
specialist shop. If there is too much
rust, replace the blades with new
ones.
3. Have the blades sharpened in a
specialist shop.
85305 - 07.2021 - V2