PSH EOLO Serie Mode D'emploi Et D'entretien page 5

AIR BLOWER PUMP
INSTRUCTION MANUAL
Characteristics of the product:
Large wind, low noise.
Heater quick-dry function.
Thermal protector TP16050.
Fuse inside the motor.
Insulation class F.
Noise of the air blower pump with a nozzle as follows:
Model
EOLO APW400
Average noise
73
in dB (A)
Parts and materials:
Pump casing: high temperature resistant.
Reinforced plastic.
Air switch: 15 A, 250 V (optional).
High quality carbon bush.
Use and installation:
The number of nozzles installed must be higher
than the minimum number indicated.
The installation of the air distributor must be higher
than the water-level in case that water can come
into the air blower pump (Fig. 1).
The connection pipe of the air blower pump must be
temperature resistant.
The air blower pump must be installed fixed, and
the connection pipe must be fastened.
Air blower pump
Drain
Drain valve
(Fig.1)
EOLO APW700 EOLO APW900
75 78
Check valve
Air-distributing pipe
Technical parameter list
Model
EOLO APW400
EOLO APW700
EOLO APW900
Dimensions
64
148
172
175
Provided with coupling sleeve Ø50 mm.
CAUTION
The air blower pump must be grounded in order to
prevent electrical shock or injury.
The air distributor must be installed higher than the
water-level of the tub, in order to prevent the water
flow into the air blower.
The outlet of the air blower pump mustn't
be stuffed up when it's operating.
If the outlet air flow is too small, the air
temperature will increase. Pay attention to prevent
scald.
n ̀ compliance ith ̀
aste ̀ electrical and electronic euipment ̀ (EEE), ̀ the
products mared ̀ ith ̀ this symbol must be deposited
at the local recycling center in each region for their
selective collection, optimize the recycling of the
components and materials and, reduce the impact on
human health and the environment.
he ̀ consumer should contact the local authority or
the seller to inuire ̀ about the proper disposal of their
appliance.
- 4 -
Power (W)
Nozzles quantity
360 400
12〜24
630 700
16〜32
820 900
20〜40
72
104
274
the Directive 2012/19/EU for