After Use & Storage; Cleaning & Maintenance - Foro LS7300 Mode D'emploi

AFTER USE & STORAGE
• Turn the control knob on the appliance clockwise to the 'OFF' position.
• Turn the gas supply off at the cylinder.
• Do not leave the area until the flames have fully extinguished.
• Children must not be left unattended straight after use as the appliance will still be hot for some
time.
• Check the gas valve for tightness and damage. If damage is suspected this must be changed by a
qualified technician.
• Always store gas cylinders in well ventilated areas.
• Once the heater has cooled down, it can be moved to an alternative location such as a garage of
shed and it is safe to use a rain cover for protection.
CLEANING & MAINTENANCE
• Ensure all cleaning is done while the heater is turned off and has fully cooled down.
• Wipe surfaces with a soft, damp cloth.
• Do not use any corrosive or combustible cleaning solutions.
• Keep the outdoor fire covered when it is not in use to stop rain from blocking the burner jets.
• Make sure the burner is kept clean and clear of combustible materials and dirt.
• Soot can build up on the glass beads, lava rocks and ceramics logs. This could block the burner jets
so remove the fuel bed and clean them with a damp cloth to remove the soot.
• Soot can build up on the surrounding safety glass. Carefully remove the glass from the glass bracket
with a screwdriver, wipe off the soot with a soft, damp cloth. Then carefully place the glass back.
Two people may be required for disassembly and reassembly of the surrounding safety glass.
• Ensure a suitable condition of the gas hose and make sure it shows no signs of cracking or general
wear and tear.
• We advise to get the appliance checked by a qualified technician every three years.
• If the burner jets get blocked by soot or other dirt, then remove the fuel bed and use a pin or
paperclip. Ensure the burner is switched.
• Follow the above maintenance steps on a regular basis.
FØRO LS7300 - MANUAL
15
EN