fluidra VSN-10 Manuel D'instructions page 20

4.2 Accessories Installation
Anti-vibration bases
1. Take out 4 Anti-vibration bases
2. Put them one by one on the
bottom of machine like the picture
Draining jet
1. Install the draining jet under the
bottom panel
2. Connect with a water pipe to
drain out the water.
Note: Lift the heat pump to install
the jet. Never overturn the heat
pump, it could damage the
compressor.
Water Inlet & outlet junction
1. Use the pipe tape to connect the
water Inlet & outlet junction onto the
heat pump
2. Install the two joints like the picture
shows
3. Screw them onto the water Inlet &
outlet junction
Cable wiring
1. Open the cover of the electric
box
2. Fix the power supply wire on
joints L N E
16