Connect The Loads; Connect Telephone / Network Surge Protection And Rs232 - Atlantis Land OnePower A03-PS651 Mode D'emploi

OnePower Line Interactive UPS (EN)

1.5 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS. To use the UPS as a master "On/Off" switch,
make sure that all of the loads are switch "On".
Caution: Do not connect a laser printer to the outlets. These UPS outlets
provide battery power and surge protection to the equipment when utility voltage
is outside acceptable limits.
1.6 Connect telephone Surge protection and RS232
Connect a single line telephone or a 10 base-T / 100 base-T network cable into
the RJ-45 / RJ-11 telephone / network surge protection "IN" jack on the back of
A03-PS651 Pag. 19