Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
6)
• Squeeze the Release Handles on both
sides simultaneously and push the tube
through the Height Adjusters until it locks
in the highest position (Fig. 6).
7)
• Connect the Front and Rear Legs to the
Upper Frame Assemblies by inserting the
tube ends into the extension tubes (Fig. 7).
NOTE: Legs are properly connected
when the lock buttons are lined up with
the holes on the ends of the Upper Frame
Assemblies. Make sure the lock buttons
are engaged before use.
8)
• Attach each of the Casters to the high
chair legs (Fig. 8). Snap casters into
Bottom of the leg.
NOTE: Check that all four Casters are
securely fastened to the High Chair.
7
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
All manuals and user guides at all-guides.com
Release Handle
Fig. 6
Lock Buttons
Fig. 7
Fig. 8
9)
• Loop the flap on the back of the pad over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the two Elastic Loops. These fit over the
Attachment Tabs located near the top harness slots (Fig. 9a).
• Attach the bottom of Seat Pad to the Seat Base with the two Elastic
loops located at the rear of the bottom of the Seat Pad. These fit over the
Attachment Tabs located on the Seat Base near where the Seat Back and
Seat Base Join (Fig. 9b).
• Attach each anchor hook of the Seat Pad to the side of the seat armrest
(Fig. 9c). Ensure that the slot of the anchor hook slides through the under
side division (Fig. 9d).
Fig. 9a
Fig. 9c
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 9b
Fig. 9d
8
Publicité
