Installing The Router - JessEm Tool Mast R Lift II Mode D'emploi

IMPORTANT SAFETY PRECAUTIONS CONT'D
.
• Do not wear loose clothing or jewelry that
may catch on tools or equipment.
• Unplug the tool or machine when mounting
or making any adjustments to mechanical
performance
DO NOT USE A CORDLESS DRILL TO
RAISE AND LOWER THE LIFT
CARRIAGE. THE AMOUNT OF
FRICTION WILL CAUSE PREMATURE
WEAR OF THE THREADS AND WILL
VOID WARRANTY
ROUTER SAFETY PRECAUTIONS
•
Never force the bit or overload the router beyond
the expectations of the tool.
•
Be sure that at least 3/4 of the shank length is
inserted securely in the router collet.
•
Never bottom out the bit in the collet. Allow 1/8"
clearance between shank and bottom of collet.
•
Always make sure the fence on your router
table is locked into position before each
use.
•
Always rout in two or more passes when
large amounts of stock must be removed.
•
Use reduced RPM speeds for large
diameter bits.

INSTALLING THE ROUTER

Place the crank handle into the hex hole in the lift's
dial on the top plate. Crank the lift carriage up so that
it just contacts the O-rings at the top of the carriage
shafts. The carriage should be all the way toward
.
the top plate
Figure 1
Before installing the router motor, prop the unit up
on blocks of wood (Fig. 1) so the router's collet can
extend through the center hole in the top plate.
The motor housing must be able to slide all the
way through and contact the inside back of the
center hole on the plate.
1. With a 1/8" hex key, remove one of the ¼"
shoulder bolts from one of the clamping blocks
and slide the clamping block on the carriage (Figure
2)
Figure 2
2. Locate your router on the chart below.
3. Align the letter and number associated with
your router (Figures 3 and Figure 4) and reinsert
and tighten the ¼- x 1-1/2" Shoulder Bolt you
removed in step 2.
4. Repeat this for all four carriage clamping blocks
ROUTER CHART
Porter Cable 7518
JessEm 05200 Pow-R-Tek Motor with Remote
Switch
Porter Cable 690/890, Bosch 1617/1618,
DeWalt 610/618, Craftsman
17543/17540/28190
Makita 1101
Hitachi M12VC/KM12VC
Milwaukee 5626
Milwaukee 5615/5616/5619
Rigid R29302
A1
F4
C1
E2
D3
G3
B1