Parts And Features; Important - Hotpoint Ariston WATER MACHINE Mode D'emploi

en

PARTS AND FEATURES

1. Water Machine Unit
2. Reservoir Lid
3. Reservoir
4. Dispensing Button and Self Monitoring Sy-
stem Warning
5. Faucet
6. Drip tray
7. Screwdriver

IMPORTANT

• This appliance is for use with potable drin-
king water only. Never use this appliance
with unknown or unsafe sources.
• This appliance needs a regular periodic
maintenance to assure the drinkability requi-
rements of treated water and improvements
preservation as declared by the Manufactu-
rer.
• Check if the voltage indicated on the ap-
pliance corresponds to the local mains volta-
ge before you connect the appliance.
• Do not use this appliance if the mains cord,
plug or other parts are damaged.
• Do not allow children to use the appliance
without supervision.
• Never leave the appliance unattended when
water is being dispensed.
• For a cold refreshing drink the reservoir may
be stored full of water in the fridge.
• Do not overfill the reservoir and do not leave
the water goes below the min level marked
on the reservoir: running the with a lower le-
vel of water will cause bubbling noises as the
pump will then suck in air.
• Only use original parts from the manufactu-
rer to repair and service the unit.
• Only use Hotpoint-Ariston [Hotpoint] UV
lamps and filters with the appliance, failure
to do so will void the warranty.
• The UV lamp will turn on for 60 seconds
should the appliance not be used for 3 hours
• Make sure the appliance is placed on a flat,
level, dry and secure surface.
• Read all instructions contained in this user
manual prior to using this appliance.
12
• This Class A system conforms to NSF Stan-
dard 55 and P231 for the disinfection of
micro biologically contaminated water that
meets all other public health standards. The
system is not intended to convert wastewa-
ter or raw sewage into drinking water. The
system is intended to be installed on visually
clear drinkable water.
SET-UP
Check the unit for any damage, if the appliance is
damaged then please return to the place of pur-
chase.
A1 Insert the plug into the mains socket. When
the mains power is switched on the appliance will
automatically go through a self check/test and
once this is complete the button will turn blue.
A2 Remove the water reservoir from the main
body of the appliance .
A3 Remove the lid from the reservoir.
A4 Rinse the reservoir very well and then fill the
reservoir from a potable water source. Do not
overfill the reservoir.
A5 Wash the lid thoroughly (for cleaning proce-
dures read point 3.1) and re-fit it to the reservoir.
A6 Re-fit the reservoir to the appliance making
sure it is firmly fitted.
The steps A1-A6 can also be done wi-
thout removing the reservoir from the