Nordic Deltaco DUR-798 Mode D'emploi page 2

ENG - User Manual
Safety instructions
1. Do not look into or observe the device's light, neither directly or through an optical instrument.
2. Do not disassemble or remove the lens cover. If the lens cover is removed, your eyes will be directly exposed to the light.
3. Opening up, adjusting or repairing the scanner is only allowed by a qualified professional.
4. Keep the product away from children.
5. Do not expose the product to shock damage, pressure or put the product into fire or immerse in water.
Do not continue to use the product if it has been damaged or deformed. Do not leave it in hot environments.
Product information
This barcode scanner provides an accurate, fast and easy complete solution for data entry and storage for computer
information systems.
The product has two working modes: manual and auto-sensor.
This product provides 4 interfaces to connect to any host computer system: Keyboard (Keyboard wedge), RS-232, USB
HID and VCOM.
Configure this device by scanning bar codes. The settings are stored in EEPROM type memory, which are saved even if
the device has been powered off.
This product has more settings than available barcodes in this manual. If needed you can create your own barcodes to set
your own settings. One example is the "LED on time", it has about 200 possible settings but only 4 examples of barcodes
are in this manual. See the English section "Configuring the barcode reader" for the corresponding setting you want to
create or change.
Scan barcodes
In order to obtain a good scan effect, you should aim the barcode reader at the center of the barcode, but you can aim
from any direction.
The closer the scanner is to the barcode, the smaller the aiming beam is;
the farther away the scanner is from the barcode, the larger the aiming beam is.
If the barcode is small, the scanner should be close to the barcode; if the barcode is large, the scanner should be farther
away from the barcode, so the barcode can be read easily and correctly.
If the barcode is highly reflective (e.g., coated), you may need to tilt the scanner to read the barcode.
3.
4.
2.
5.
Cable removal
1. Locate the cable removal hole on the bottom of the scanner.
2. Insert a paper clip into the hole and press firmly on the paper clip while gently pulling the cable out.
Readability VS performance
Each type of barcode has its own unique properties. Enable the ability to read barcode types via the settings found in this
manual. You can disable the scanner from reading barcode types that will not be used to improve the scanner's performance.
Maintenance
1. Stains and dust on the scan window may affect the scanning. Use a lint-free cloth / lens tissue of good quality to gently
wipe clean the window if needed. Poor quality paper will damage the surface smoothness of the scan window and affect
the scanner's effect.
1.
Scan window
2.
Button
3.
1.
LED
4.
Sound output
5.
Cable removal hole
1