ONE DUPRAY Manuel D'utilisation page 21

PROBLEM
Pressure is dropping during operation.
Machine is not heating.
The electrical cord is damaged.
The hose keeps falling out of the
connection outlet.
The white lever on the rectangular or
triangular tool cannot change position.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
A. Pressure set to max for too long.
A. Out of water (light may not be on).
B. Styeam cleaner is OFF.
A. Replace power cord.
A. The hose is not properly connected.
A. The arrow on the connector and the dot
on the tool are not lined up.
REMEDY
A. Use lower pressure setting.
A. Follow the instructions on page 08.
B. Turn to setting.
A. Contact Dupray at + 44 333 011 2660 for
replacement.
A. Make sure you push the hose in all the
way and ensure the locking pin is in
place.
A. Rotate the connector so that the arrow
on the connector and the dot on the
tool line up. Slide the white lever to
the correct position.
en
20