Table des Matières
Publicité
not use an extension cord.
NOTE:
Before performing any type of installation, disconnect the
refrigerator from the electrical source. When you are finished,
connect the refrigerator to the electrical source and reset the control
to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may not
close or seal properly, causing cooling, frost, or moisture problems. It
is very important of the refrigerator to be level in order to function
properly.
To level your refrigerator you may either turn the level leg clockwise
to raise that side to the refrigerator or turn counter – clockwise to
lower that side.
NOTE:
Having someone push against the top of the refrigerator take
some weight off the leveling leg. This makes it easier to adjust the
leveling leg.
USE OF THE APPLIANCE
To obtain the best possible results form your refrigerator, it is
important that you operate it properly.
Temperature Control
Controls for the refrigerator and freezer are located at the fop shelf of
the refrigerating compartment. When you first install your
refrigerator, set the Thermostat knob at 3. Give your refrigerator
time to cool down completely before adding food. It is best to wait 24
hours before adding food.
The thermostat knob controls the temperature. The higher number
setting, the longer the compressor will run to keep the temperature
Publicité
Table des Matières
