Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
4. CONNECTIONS
• Make sure that the power switch is set to "OFF". Before you connect the devices, all units have to be
switched off and the faders are set to "0".
• In order to obtain highest sound-quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• The Master-output can be connected via the RCA-sockets. Make sure that the sockets are set properly
(L & R).
• For recording, connect your tape recorder or cassette deck to the REC OUT-sockets.
• You can connect up to 2 record players using the PHONO 1 sockets and PHONO 2 on the rearpanel. You
can only control the record player signal after you switched the PHONO/LINE switches to PHONO. The
signal is then controlled via the CH-1 and CH-2 faders.
• Connect your CD-player, DAT-recorder, cassette deck, tuner, tape recorder or all other line signals to the
LINE input-sockets on the rearpanel. You can only control the line signals after you switched the
PHONO/LINE switches to line. The signal is then controlled via the respective faders.
• Switch the device on. After switching on the amplifier, wait 8 to 10 seconds until you turn the volume-
controls in order to avoid speaker-damage.
• Under all circumstances avoid amplifier clipping. Distorted signals are the major cause of speaker-damage.
13
Publicité
Table des Matières
