Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing Your Ice Maker
9
If hole in the back of the cabinet
is as illustrated to the right , then
push gently on the water fill tube
while twisting it slightly. Make
sure flange (E) is
firmly seated in the
hole
• Pull on back of fill tube
to be sure that the
fit is tight. If tube comes
loose, repeat above
instructions.
or
If hole in cabinet
back is diamond
shaped, then insert
fill tube. Press
firmly inward while
rotating clockwise
30° until water line
is vertical and fill
tube is locked into
back wall.
• Pull on back of fill tube to be sure that the fit is
tight. If tube comes loose, repeat above
instructions.
E
°
30
How to Mount the Water Valve
Assembly
1
Locate water valve
cover plate on back of
unit in lower left hand
corner. Remove cover
plate with a ¼" hex
nut driver.
• Retain screw for later replacement.
• Cut wire tie holding harness to cover plate.
Take care not to cut wires.
• Discard cover plate
2
Plug harness from
inside machine
compartment onto
water valve electrical
terminals.
3
Tuck bottom portion of
valve inside machine
compartment behind
the tab (G) and fasten
valve to cabinet with
¼" screw (F) from step
1.
4
Position valve water
line as illustrated
and secure with
small
plastic adhesive
clip (A) located
in ice maker kit.
6
F
G
A
Publicité
Table des Matières
