Marvel 30iMT Mode D'emploi page 15

is attached to the door and cabinet. After the panel is removed
from the door, drill the mounting holes from the front, to the
recommended diameter of the handle manufacturer. Counter
bore the back-side of the panel so the screw heads do not inter-
fere with the surface of the door.
Top hinge
adapter
Figure 12
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the screw
pilot holes for attaching the overlay panel to the door. Select
the size of the hole from Table B. Be careful not to drill the pilot
holes through the overlay panel, (1/2" (12.7mm) deep for 3/4"
(19mm) and 5/8" (15.7mm) panels ).
Step 7: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay panel to
the door. (See Figure 13).
Step 8: Install door gasket
Press the door gasket into the door channel. Make certain the
gasket corners are fully inserted. If applicable insert the key into
the lock and make certain the lock operates properly.
Step 9: Install the door
Install the top and bottom hinge adapter bushings back into the
hinge adapters that were removed in step 6. Install the door by
reversing the procedure from step 2. Install the top hinge pin so
the screw head is flush with the top surface of the hinge. If appli-
cable insert key into lock and verify the lock cam works properly
with the catch bracket on the front of the ice machine cabinet.
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Hole in hinge
adapter
Door
Overlay
panel
Hole in bottom
hinge adapter
Material Type
Hardwood
Softwood
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge
cam
Bottom hinge pin
15
#8 Wood Screw
1/8" (3.2mm) Diameter. Pilot Hole
7/64 (2.8mm) Diameter. Pilot Hole
Table B
Figure 13
Top hinge
Figure 14
Right hand
hinges shown
Bottom
hinge