ABANTERA 135I13T20NT Mode D'emploi page 44

SENSOR (clean regularly)
1. Clean the sensors along the edge of the robot.
2. Clean the three anti-drop sensors located on the bottom front of the robot.
3. Clean the anti-collision infrared sensor located on the front of the robot.
4. Clean the electronic shock shield and any dirt from the charging base at the bottom of the
robot.
5. Clean the signal transmission area of the charging base.
Anti-drop sensors
42 |
Cleaning and
Wall sensor
U N I T E D
MAINTENANCE
ATTENTION
Clean the sensors with a soft cloth.
Disconnect the machine from power
during cleaning.
Charging contacts
S TAT E S