Publicité
Les langues disponibles
Les langues disponibles
MOUNT PLATE FOR "GLACIER PRO" PLOW FRAME
KIT PN 2879106
INSTALLATION INSTRUCTIONS
1.
Fasten the upper part of the mount plate a to frame
using the
(4) M12-1.75 X 30 mm
supports d, and the
(finger tighten at this time).
2.
Fasten the lower part of the mount plate a to frame
using the
(2) M10-1.5 X 35 mm
nylock flange nuts g.
M10-1.5
Tighten all bolts and nuts.
NOTE : Be sure to use the correct mounting holes.
Front of
the Vehicle
7515259
A-7515259
hex bolts f, the
(2)
nylock nuts h
(4) M12-1.75
FRONT VIEW
hex bolts e and the
(2)
LEFT FRONT VIEW
3.
Assemble the lift rod c to pushframe as illustrated.
NOTE : The "V" shape of the lift rod must be
downwards.
USE THE PUSHFRAME WITH ANGLE OR
LIFTING HYDRAULIC KIT
To allow the installation of an angle or lifting hydraulic
system, a new front grille b is included in this kit. This
grille is composed of an opening for easy installation of
a hydraulic system.
1.
Remove the roller guide if it's installed.
2.
Remove the existing front grille. Retain the bolts.
FRONT VIEW
- 2-
Printed in China
Publicité
