SAFETY PRECAUTIONS
General Safety Precautions
–
The installation of solar photovoltaic systems requires specialized skills and
knowledge. The installer assumes all risk of injury, including risk of electric shock.
Module installation should be performed only by qualified persons.
–
All modules come with a permanently attached junction box and PV cable
terminated in MC4® compatible PV connectors. Your dealer can provide
additional cables for extension or addition of extra solar panels.
–
Exercise caution when wiring or handling modules exposed to sunlight.
–
Do not connect or disconnect wires attached to photovoltaic modules when
modules are exposed to sunlight, otherwise an electric arc may occur. Arcs
can cause burns, fires or other safety problems. Always exercise caution when
connecting and disconnecting wiring on modules.
–
Photovoltaic solar modules convert light energy to direct-current electrical
energy and are designed for outdoor use. Proper design of support structures is
the responsibility of the system designer and installer.
–
Modules may be ground mounted, pole mounted, or mounted on rooftops.
–
Do not attempt to disassemble the module, and do not remove any attached
nameplates or components. Doing so will void the warranty.
–
Do not apply paint or adhesive to the module.
–
Do not use mirrors or other hardware to artificially concentrate sunlight on the
module.
–
When installing modules, observe all applicable local, regional and national codes
& regulations. Obtain a building and/or electrical permit when required.
–
These solar modules are not rated for grid-tied solar systems, they are meant
solely for off-grid solar systems.
Work Safely
–
Wear protective eye wear and appropriate clothing during installation. Use
extreme caution when working with electricity and when working around
batteries. Use properly insulated tools only.
–
Use care when working on an RV roof, always use rated safety harnesses and
ladders during installation and maintenance.
- 4 -
CCD-0005510 Rev: 04-15-22