Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FSEB30JWO-BL
FBF12A100E
MPPT Solar Charge Controller
FSCC30PW-BL
FSCC60PW-BL
WARNING: Electrical shock hazard! Do not touch bare conductors or other
potentially energized parts.
–
Any hardware used must be compatible with the mounting structure material to
avoid galvanic corrosion.
–
It is not recommended to use modules with different configurations (grounding,
wiring) in the same system.
–
The current, voltage, and power characteristics of the solar panel(s) will vary
based on environmental criteria including temperature and solar irradiance.
–
To prevent cables and connectors from overheating, the cross section of the
cables and the capacity of the connectors must be selected to suit the maximum
system short circuit current (the gauge of system cables is determined by the
system designer or installer.).
SHUTTING DOWN THE SYSTEM
1.
Completely cover system modules with an opaque material to prevent electricity
from being generated while disconnecting connectors.
2. Disconnect system from all power sources in accordance with instructions for all
other components used in the system.
The system should now be out of operation and can be dismantled. In doing so,
observe all the safety instructions as applicable to installation.
Rooftop Solar Electrical Box
LiFePo4 Battery Pack
Fuse
+
Battery
FBF12A100E
Disconnect
Fuse\Breaker
Optional
System Connection Diagram
- 8 -
Temperature Sensor
C-FSCC60PW-A01
C-FSCC60PW-A02
-
-
CCD-0005504 Rev: 02-10-22
Rigid Solar Panel
FSFP37MW-BL
+
-
Rooftop Solar
Electrical Box
FSEB30JWO-BL
Publicité
Table des Matières
