Beper BB.103 Mode D'emploi page 8

Electric Kettle Use Instructions
Put the attachment of lid and filter slowly inside the kettle with water already ready (If necessary switch on the
kettle the second time).
If tea is not to be served immediately after the brewing time, it is recommended to remove the filter with used tea
leaves from the hot water to avoid their prolonged contact with water, that may alter the flavour and taste of tea.
Close the kettle with the lid after removing the filter.
Cleaning
Unplug the appliance from the socket.
Let it cool down and clean with a damp sponge.
Do never use abrasive sponge to clean it.
Clean regularly, at least one a month if the water is had or more if the water is very hard.
To remove lime scale, use
White wine vinegar 8°
Fill the kettle with ½ liter of vinegar.
Let it for about one hour without heating it.
Empty the kettle and rinse 5 or 6 times.
Repeat if necessary.
Acid citric
Make boiled 1 liter of water – add 25 g of acid citric and let it rest for about 15 minutes.
Empty the kettle and rinse it 5 or 6 times.
Repeat if necessary.
Do not use other methods or detergents to remove limescale.
In case of
Use while empty
The kettle is on but without water in or the limescale activates the safety system and blocks the unit: let the
kettle cool down and fill it with water. Use the on/off switch to turn it on: the kettle will start again after approx.
15 Minutes.
Smelly water
It does happen when the kettle is new. For the first times of use, throw away water. If the problem remains, fill
the kettle to MAX. level, and add 2 spoons of bicarbonate; boil it, throw away water and rinse the kettle body.
Technical data
Power: 1850 - 2200W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8