Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
• Always keep the Pick/Pack tool clean before inserting back into
the housing
• Use a key to assist removing the Pick/Pack tool from the
housing if its stuck
Ensure GO Button is lit up Green or Blue
2
2)
2
to increase or decrease the Session Time
• 4 White LEDs...
• 3 White LEDs...
• 2 White LEDs...
• 1 White LED...
Top 3 reasons to use the Pick/Pack Tool
1) To secure and remove oven screen
2) To stir materials at any point before,
during or after a session
3) To easily remove materials in
preparation for a reload.
1)
Press and Hold both the (+) and (-)
Individualy press the (+) or (-) buttons
(30, 60, 90, 120 seconds)
3)
White LED will indicate session time
120 Seconds
90 Seconds
60 Seconds
30 Seconds
buttons simultaneously
5
Publicité
Table des Matières
