Hydor Smartwave Mode D'emploi page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Installation
Choose carefully where to position your new Smartwave, make sure it is an accessible and safe place, no risk of falling in water (aquarium or sump), out of reach of children
and possibly not too humid. Use a screw or very strong Velcro (both not included) to attach the controller to the cabinet or where desired.
attention: remember that each channel/connector can tolerate up to 100W Max. Position your pump/s (not included) in your aquarium depending on your personal needs
and then follow the simple instructions to program your controller.
programming with 1 pump connected
Connect your pump to one of the Smartwave channels (if connected to the right-hand channel, when the system is
turned on, the pump will start in ON, if connected on the left-hand side the pump will start in OFF)
Select "I" with program knob (B) fig 1
Select time exchange between ON-OFF with right-hand knob (C) fig 2
Turn Smartwave on with the ON-OFF switch (A) fig 3
The blue LED will confirm the correct start up of the system and will light up when the pump is working
(pushing water).
From the moment Smartwave is turned on the pump will run on and off following the time set.
programming with 2 pumps connected
Each channel/connector can tolerate up to 100W Max. ATTENTION: pumps will follow programs set, they can not be programmed separately.
Do NOT exceed 100W per channel.
Connect your pump to one of the Smartwave channels
SYnCHronoUS
p r o G r A m
With program knob (B) fig 1 select "I" if you wish the pump to function in alternate mode or "II" if you wish the pump to function in synchronous mode.
Select time exchange between ON-OFF with right-hand knob (C) fig 2
Turn Smartwave on with the ON-OFF switch (A) fig 3
The blue LEDs will confirm the correct start up of the system and will light up when the pumps are working (pushing water).
A l t E r n A t E
proGrAm
From the moment Smartwave is turned on the pump will run on and off following the time set.
fig 1
fig 2
fig 3
English
7

Publicité

Table des Matières
loading

Table des Matières