Taymor 06-V0010 Mode D'emploi

INSTALLATION INSTRUCTIONS
06-V0010
3-WAY DIVERTER VALVE
THIS FAUCET MEETS OR EXCEEDS THE FOLLOWING STANDARDS:
cUPC, ASME A112.18.1
THANK YOU FOR PURCHASING THIS TAYMOR PRODUCT. ALL TAYMOR PRODUCTS ARE CARE-
FULLY ENGINEERED AND FACTORY TESTED TO PROVIDE LONG TROUBLE-FREE USE UNDER
NORMAL CONDITIONS
WARNING: READ ALL the instructions completely before beginning installation.
READ ALL warnings, care, and maintenance information.
Taymor recommends calling a professional if you are uncertain about installing this
product!
This product should be installed in accordance with all local and provincial plumbing
and building codes.
HAVE BASIC TOOLS READY
1
RECOMMENDED TOOLS:
Teflon tape Slotted and Phillips
screwdrivers
Propane torch Hacksaw or
and solder Tubing Cutter
TURN OFF THE MAIN WATER SUPPLY
2
Locate water supply and shut off water supply
valves. These are usually found near water meter.
INSTALL 3-WAY
3
DIVERTER VALVE
Determine the desired location of
the diverter above the Pro/Valve
and mount it on the support frame.
Recommended valve depth is 1-1/2"
min. to 2-1/2" max. from the center
of the diverter connector to the
finished wall as shown.
Adjustable Wrench Strap wrench Torque wrench
and Pipe wrench
Flashlight
Pliers
TURN OFF
1-1/2" 2-1/2"
-
(38 mm) (83.5 mm)
1-1/4"
(31.1 mm)
DIVERTER
VALVE
1-1/4"
(31.1 mm)
PRO/VALVE BODY
1-1/2"
-
(38 mm) (83.5 mm)
REMOVE PROTECTIVE CAP
4
Remove the protective cap (1) from the valve (2).
PRO/VALVE AND DIVERTER VALVE CONNECTION
5
Connect Pro/Valve to the IN connection of the diverter valve.
DIVERTER VALVE WATER OUTLET CONNECTIONS
6
If using tub & shower Pro/Valve, please follow step A. If using shower only
Pro/Valve, please follow step B.
A
B
Thermometer
TURN OFF
FLUSHING
7
IMPORTANT: Before closing wall openings, pressure test the valve and
complete system using flushing instructions.
Pipe chips, sand and other solids found in new and renovated plumbing
can damage the sealing surfaces of the cartridge causing leakage or
spool blockage. To avoid damage, DO NOT TURN ON SUPPLY VALVES until
instructed.
Make sure both hot and cold supplies are off. Rotate cartridge stem to relieve
pressure and insure complete shut-off. Remove the cartridge. Slowly turn
on both hot and cold supplies and flush out the body and lines. Close the hot
and cold supplies and replace cartridge. Turn on both supplies and check the
system for leaks.
2-1/2"
CUSTOMER SERVICE
2
1
FUNCTION 2
FUNCTION 1
FUNCTION 3
Connect water outlets to corresponding functions.
Use cap provided to block unused outlet.
FUNCTION 2
FUNCTION 1 FUNCTION 3
Connect water outlets to corresponding functions.
Use cap provided to block unused outlet.
WEST 1-800-267-4774 | EAST 1-800-387-7064 | taymor.com
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.