Extreme Max 5001.5809 Instructions De Montage page 2

Standard Installation Instructions:
1. Place the hitch weldment onto the tractor's hitch plate. Align the hitch weldment's mounting slot with the hitch plate's
hitch ball mounting hole.
2. Insert the carriage bolt down through the aligned holes. Secure it with the washer, M16 washer, M16 split lock washer,
and M16 hex nut as shown.
Optional Installation Variant:
Mounting holes in the hitch weldment are included to further secure the weldment to the tractor. However, hardware is
not included. If desired, use the following instructions:
1. Place the hitch weldment onto the tractor's hitch plate. Align the hitch weldment's mounting slot with the hitch plate's
hitch ball mounting hole.
2. Use the hitch weldment as a template to mark the locations of the two mounting holes at the end of the hitch
weldment. Remove the hitch weldment.
3. Drill a 3/8" hole through the tractor's hitch plate at both marked locations. Replace the hitch weldment, then align the
mounting slot and mounting holes.
4. Insert the carriage bolt down through the mounting slot and hitch ball mounting hole. Secure it with the washer, M16
washer, M16 split lock washer, and M16 hex nut as shown.
5. Use additional hardware to secure the hitch weldment at both mounting hole locations. Use only high-grade stainless
steel hardware.
2