Publicité
Towel Warmer Installation Procedure
STEP 1
Rough-in Requirements (see figure 3)
1. The incoming power feed goes to a deep single gang
electrical box (for the controller). This electrical box
can be located anywhere in the room, although we
recommend it be alongside your light switches.
2. A power feed then goes from the controller electrical
box to a single gang electrical box (for towel warmer).
The location of this electrical box governs the location of
your towel warmer (see figure 2).
3. Wall studs or plywood backing is required in the wall at
all bracket locations. See figure 2 for bracket locations.
Figure 1
STEP 3
Hardwire Connection (see figure 4)
Do not connect the towel warmer to the power supply until all instructions have been read and installation carried out in accord
with them. The heating element is 150W or 300W 110V. The element conforms to UL standards and the unit to CSA standards
(File ref: 229718). Ensure the CSA label is visible. TURN OFF POWER SUPPLY BEFORE PROCEEDING.
1. Feed the electrical cord located at the side of the Towel Warmer first through the round tube and then through the cover plate.
2. Complete all electrical connections as shown in figure 3.
3. Fit tube over Towel Warmer element sleeve until it meets the hexagonal chrome collar.
4. Push cover plate onto tube.
5. Screw cover plate to electric box with the enclosed screws. Adjust where necessary.
STEP 2
Installation Instructions (see figure 1)
1. Check all items have been received. You should have
towel warmer, hardwire kit, programmable timer and
mounting discs including fixings. Read all instructions
before continuing.
2. Fix mounting discs "A" to the wall using the screws
provided and in locations as shown on figure 2.
3. Mount towel warmer and slide brackets "B" over
mounting discs "A".
4. Fasten towel warmer using set screws "C" to lock
mounting discs "A" into brackets "B". Ensure the Towel
Warmer is firmly and safely fixed.
A
C
C
B
877-757-8930
www.icobath.com
Publicité
