EA NSX 1500 Notice D'utilisation page 13

Notice d'utilisation: NSX 1500 Table de mixage 3+1 canaux
7.
Protection from electric shock:
1.
2.
3.
4.
5.
6.
7.
Protection from fire:
1.
2.
3.
13
The manufacturer takes no responsibility for injury or damage
caused by not following the safety precautions and instructions
printed in this manual.
Only connect this unit to a mains socket outlet with protective
earth connection, ground-fault (earth-fault) protection and
overload protection.
Where the mains plug or an appliance coupler is used as a
dis-connect device, the disconnect device shall remain readily
operable.
To pull the AC Cord out of the wall outlet or the unit's AC
socket, never pull the cable itself, but only the AC plug.
Disconnect the unit from AC supply by pulling the AC plug out
of the wall outlet or the unit's AC socket before any kind of
cleaning on the product. Use smooth and dry cloth only for
cleaning. Check all connection cables before reconnecting the
unit.
Do not expose this unit to any dripping or splashing liquids,
and do not place objects filled with liquids, such as vases, on
the unit. Do not operate this unit near to open water or in high
humidity.
Choose the position of the AC cord according to the lowest
risk of damage by foot steps or by squeezing it. Take
especially care of the AC cord outlet on the unit as well as the
AC plug and wall outlet at the other end of the cable.
Do not open the unit for service purpose, as there are no user-
serviceable parts inside. Warranty will be void in any case of
unauthorized service by the user or other not authorized
persons.
Take care of not placing the unit near sources of heat (e.g.
powerful amplifiers, fog machines).
Take always care of sufficient air convection in the unit's
environment to avoid overheating, especially when mounting
in a closed environment. Make sure air convection slots – if
any - are not blocked. Do not operate this unit in
environmental temperatures exceeding 40 degrees Celsius.
Check the total maximum power of your AC wall outlet if you
connect several units to one wall outlet and avoid any
overloading