LiftMaster 885LM Guide Rapide page 2

TO ERASE ALL CODES FROM GARAGE DOOR OPENER MEMORY
(REMOTE CONTROLS, KEYLESS ENTRIES AND WIRELESS CONTROL
PANEL)
To deactivate the accessories, first erase all codes:
Press and hold the "Learn" button on the garage door
opener until the learn indicator light goes out
(approximately 6 seconds). All previous codes are now
erased. Reprogram each remote control, keyless entry or
wireless control panel you wish to use.
INSTALLATION
NOTE: Install the door control within sight of the garage door at a
minimum height of 5 feet (1.5 m) where small children cannot reach, and
away from the moving parts of the door.
1. Mark the location of the bottom mounting hole and drill a 5/32"
(4 mm) hole.
2. Install the bottom screw, allowing 1/8" (3 mm) to protrude from the
wall.
3. Position the bottom hole of the control panel over the screw and slide
down into place.
4. Lift the push bar up and mark the top hole.
5. Remove the wireless control panel from the wall and drill a 5/32"
(4 mm) hole for the top screw.
6. Position the bottom hole of the door control over the screw and slide
down into place.
7. Attach the top screw and close the push bar.
WIRELESS CONTROL PANEL BATTERY
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212°F (100°C) or
incinerate.
The lithium battery should produce power for up to
3 years. To replace the battery, remove the two screws
and the circuit board from the plastic housing, as shown.
Insert new battery positive side up (+).
Dispose of old battery properly.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifi cations of this receiver
and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE
NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or offi ce use. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Replacement Parts
3V CR2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20
WARRANTY
ONE YEAR LIMITED WARRANTY
LiftMaster ® warrants to the first consumer purchaser of this product that
it is free from defect in materials and/or workmanship for a period of 1
year from the date of purchase.
1-800-528-9131
LiftMaster.com