Hinkley 15702 Guide Rapide

Top Cover Options
Top
15702
Glass Lens
Silicone
Gasket
15705
15708
Pivot Sleeve
Housing
LED Engine Optic Options
White
Spot Lens
Grey
Medium Spread Lens
Black
Flood Spread Lens
Concrete Burial
Make sure bottom hex
nut is tight before
burying fixture
Route to Transformer
LED Engine
or
MR16 LED
Optional
Concrete
Cap
Optional
Concrete
Burial Sleeve
Earth Burial
HINKLEY 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 HINKLEY 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkley.com
Installation Instructions
Well Light: Low Voltage | Item No. 15702, 15705, 15708
 Start Here
SAFETY WARNING: TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A
QUALIFIED ELECTRICIAN OR LOCAL AUTHORITY FOR
CODE REQUIREMENTS.
IMPORTANT OPERATION NOTE: This luminaire is designed to be
operated with Hinkley approved 12 volt AC systems.
NOTE: Luminaire can be placed in an area where a car may drive over the
luminaire.
Luminaire Mounting (for typical in-ground mounting)
1. To prevent electrical shock, disconnect transformer from electrical
supply before installation or service.
2. Luminaire may be directly buried in the ground. For concrete
applications, a removable burial sleeve and cap is included. Use cap
when pouring concrete and discard after installation of the
luminaire. (Make sure bottom hex nut is tight before burying
fixture)
3. In earth burial applications, the best way to extend fixture life is to
use sand, gravel or any other material to facilitate drainage.
4. Strip the two wire leads from the luminaire. Connect the main supply
wires using the provided silicone filled wire nuts or quick connectors
that are approved for outdoor use.
Note: Wire is to be protected by routing in close proximity to the luminaire, fitting or next to a
building structure such as a house or deck. Wiring should be buried a maximum of 6 inches (15.2
cm) in order to connect to main supply wire. The main supply wire must have its length cut off
within 6 inches (15.2 cm) from a building, structure, luminaire or fitting.
LED Engine or MR16 LED Installation
Three optics are included with the well light. A white spot lens, grey
medium spread lens and a black ood lens. Place desired optic in the
LED engine and twist to secure.
1. To prevent electrical shock, turn o transformer from electrical supply
before installation or service.
2. Using a Philips head screw driver, remove top screws and xture top.
Set these aside for use in reassembly.
3. Remove silicone gasket and glass lens.
4. Bring bi-pin socket out of housing, and insert the LED engine or MR16
LED assembly, in the socket. Making sure they are pushed into the
socket all the way.
5. Put the LED engine or MR16 LED assembly, with attached socket, into
the pivot sleeve. The engine sits in the sleeve freely.
6. Adjust the light direction by turning the pivot sleeve. The sleeve itself
can be turned 360º and the pivot cup inside has a 20º adjustment. The
screws on the pivot sleeve can be tightened to secure the cup in the
correct angle.
360º rotation
7. Return the silicone gasket and glass lens. Making sure the gasket is
seated correctly. Make sure to align the cut-outs in the gasket to the
screw holes
8. Screw the xture top back on.
With included LED engine or MR16LED
20º rotation
hinkley.com