BE PROFESSIONAL Serie Manuel D'utilisation page 2

1. 2.
3. 4.
2
USER MANUAL
OPERATING INSTRUCTIONS
14 OZ. GREASE GUN LOADING
1. Pull plunger back & lock in place. This helps seal the unit to
prevent leakage and contamination.
2. Remove grease gun head, remove plastic cap from
cartridge, and insert face down into gun.
3. With cartridge inserted, removed pull tab / flip top from
exposed end of cartridge, and replace the grease gun head.
4. Release the plunger lock, and pump lever handle several
times to prime grease gun.
**Air bleeder valves help remove air pockets from inside of
cartridge, and assist in priming the gun easier.
BULK LOADING
1. Remove or replace the plug or air bleeder valve with a bulk
loader fitting that fits the bulk loader coupler.
2. Couple the bulk load coupler to the fitting securely by
pushing in and rotating slightly.
3. Holding the grease gun firmly and securely in place, pump
the barrel pump and watch as the plunger rod extends out.
When the groove in the rod becomes visible, the gun is full.
4. Rotate the coupler back off of the bulk loader fitting to
release the gun from the pump, and push the plunger rod
back into the gun to start using.
**Do not pump beyond the indicator groove, as grease may
push past the plunger seal.
SUCTION FILLING
1. Remove grease gun head, and submerge the open end into
the bucket of grease.
2. Hold the gun firmly and securely, and slowly draw the
plunger back to fill the gun.
3. Watch for the groove in the plunger rod to indicate the gun
is full, and then lock the plunger rod in place.
4. Replace the grease gun head back onto the gun and release
the plunger lock.
**Always keep the open end of the barrel submerged while
drawing on the plunger to ensure no air gets sucked into the
gun.