Publicité
Les langues disponibles
Les langues disponibles
Installation / mounting – to be carried out by a qualified electrician only
When installing and mounting the device, observe all
safety regulations!
Dispose of the packaging material in the
appropriate collecting bins for recyclable
materials: cardboard, paper and plastics.
Mounting location
Only indoors, ambient temperatures of 5 to 30°C,
max. rel. humidity 95%.
Use screws to mount the device on a solid, flat surface
(interior wall) at a height of approx.1,5 m-if possible,
apposite the radiator.
Installation
Connect device to a permanent electric mains (24 V~)
cable (connection diagram inside device cover).
Commissioning, initial operation
Check that the device is operating correctly!
Instruct the user on how to operate the device. Give
these operating instructions to the user.
Separate clock power supply
If the mains power supply to the electrical heating
12
All manuals and user guides at all-guides.com
system is switched off, the quartz clock thermostat
power is also switched off. In order to be able to use
the clock all year round, you can set the clock to run
permanently.
• Remove the jumper between terminals 1 and 6.
• Connect the separate clock power supply wire to
terminal 6. Note: The same mains phase (e.g. L1)
must be connected to terminals 1 and 6.
Opening the device:
Use a pointed tool to remove the clock cap and
regulator knob.
1.
Publicité
